So I finally got the nerve to cook open one of my headlights so I could paint the inside two tone to match my truck. I also wanted to know if anyone has put leds in the three lines in the corner of the headlights and how they did do? I searched but found nothing that was of much help.

 

Howd the baking go?

 

I used a heat gun instead of an oven and it was pretty simple took about 30 or so minutes to have it apart

 

Check out Gold Standard Lighting, they make some awesome retrofits. I have seen some of their builds with the led strip in that spot with halos. They might be able to sell or tell you where and how to do that yourself.

 

Go to this website they sell the strips http://www.automotivelightstore.com/rigidsmdstrips.aspx

 

Look at led concepts. They make better quality concept strips then oracle so I've been told. They don't break apart as easy.

 

Those LED strips don't belong on a truck IMO. Unless your looking to "wuss down" your truck. Leave them off!

 

lets see a pic when its done, I think this would be a good idea.

 

I did one white and an orange below it that turns on with my signal. Taking them out next week when I get my LED concept halos

 

Subbed to see how the two tone turns out