I would like engine oil pressure and engine oil temp but can't seem to figure that out.

 

Kinda highjacking this post. If you post your own topic I can tell you how I did my oil temp.

 

Scangauge's webiste only says that the gauge reads these.. I see nothing about transmission temp..?


Fuel Economy
Fuel Rate
Battery Voltage
Coolant Temperature
Intake Air Temperature
Engine Speed (RPM)
Vehicle speed (MPH)
Manifold Pressure (not available on some vehicles)
Engine Load
Throttle Position
Ignition Timing
Open/Closed Loop

 

There is a built in "xguage" feature provided by the manufacturer of the SCANGUAGE II that allows it to be programmed to accept and display more guage outputs. You did not read enough on their website, as they have the information and PDF file for easily programing them into the SCANGUAGE II device. Not all manufacturers support these features; Our 04 to 08 Ford F150's support the transmission temperature (TFT) display feature. I had this displayed off of my SCANGUAGE II for two years now.

Here's the PDF off of their website to describe the additional displays other than the ones you saw:

http://www.scangauge.com/support/pdfs/XGAUGE.pdf

Keep reading!

 

Oh ok I see. So just curious, how come you're selling yours if you don't mind me asking?

 

Because I have two of them. One is installed, the other was a gift from a buddy who did not know I already had one.

 

I can PM you my e-mail or as a mod. I am sure you can find it too.