Edge Evo 2????
Thread Starter
Beasley150
Joined: Dec 2011
Posts: 360
Likes: 0
Originally Posted by BassAckwards
What on earth is the edge evo 2? Got a picture or an article that you read about this thing in?
Edge Evo 2 with ALL hardware/software: usb cable, fusion disk, OBD2 cable, both the installation manual and set up book, new dash pod mounting hardware AND comes with the gray dash pod. $250 shipped FIRM. I do have paypal. For those local, you get it for $240 FIRM. The one pic shows it after i set the truck back to stock so this is good to go.
Thread Starter
Beasley150
Joined: Dec 2011
Posts: 360
Likes: 0
Ha, shoot man everything. Or whatever you can tell me. Like what all I need to make it work right, how hard is it to hook up and use, and how to use and what does it do? Haha I know that's alot but I don't know anything about it.
I Like Tires
Joined: Aug 2010
Posts: 4,828
Likes: 250
From: Texas
Haha well first off it's a tuner. You use these often to adjust your speedo for tire sizes and gain performance and MPGs. You can also adjust for gear ratio changes in your axle to correct your speedo and adjust shift points. You can firm or soften your shift points, and control when your Torque Converter locks and unlocks.
You can change at what point in a WOT situation that the tranny shifts and how much fuel it dumps in at WOT and you can change the timing of the ignition.
You can also adjust the rev limiter and the speed limiter.
It also has gauges you can view RPMs, Vehicle Speed, Intake Air Temp, Manifold Air Flow, Manifold Air Flow Voltage, Battery Voltage, Engine Oil Temp, Engine Coolant Temp, Cylinder Head Temp, and I could go on and on.
To install all you do is plug it in to your OBD2 plug under your dash and turn your key to the "ON" Position without starting the vehicle(so don't crank the motor, the key should be in the position before that). From their the screen will guide you on what to do.
Here are some threads discussing the Edge Programmer:
https://www.f150forum.com/f4/edge-pr...ttings-112152/
https://www.f150forum.com/f4/new-edg...rammer-130451/
You can change at what point in a WOT situation that the tranny shifts and how much fuel it dumps in at WOT and you can change the timing of the ignition.
You can also adjust the rev limiter and the speed limiter.
It also has gauges you can view RPMs, Vehicle Speed, Intake Air Temp, Manifold Air Flow, Manifold Air Flow Voltage, Battery Voltage, Engine Oil Temp, Engine Coolant Temp, Cylinder Head Temp, and I could go on and on.
To install all you do is plug it in to your OBD2 plug under your dash and turn your key to the "ON" Position without starting the vehicle(so don't crank the motor, the key should be in the position before that). From their the screen will guide you on what to do.
Here are some threads discussing the Edge Programmer:
https://www.f150forum.com/f4/edge-pr...ttings-112152/
https://www.f150forum.com/f4/new-edg...rammer-130451/