I mocked up the visors to check fitment and it doesn't look right.

Following the instructions, I lined it up to the door frame and pushed the front flange between the mirror cap and door frame.



It seems like the front flange is about to pop out from behind the mirror cap and it pushes the cap out quite a bit.




If I pull the whole visor down more towards the rubber window seal to get the flange under the mirror cap better, it makes the cap stick out even more.




If anyone has these, can you take a picture of the flange under the mirror cap and where yours sit on the door frame. I want to get these put on but I don't want them pushing my mirror cap out like that.

 

I have em and had the same issue.. I believe I put the tab into the window track seam.. Check my profile for the thread I made on them..

https://www.f150forum.com/f4/avs-seamless-ventshades-blacked-out-pillars-129369/

I can get you pics when I get back to my truck.

 

Tried that. Window pushes up on it when I roll it up.

About to cut these f#*king tabs off!

If you could take a picture of where your tabs sit, that would be great.

 

Hope this helps.. I filed down the edge that is likely to contact the window..

 

Thank you. I will give it a shot.