Rigid Dually Flush Mount install
The following users liked this post:
dannytexas (08-28-2015)
#32
I did the mod to my truck. I wired it to the reverse light wire in the trailer plug harness. I also use a dremel. I used a center punch to mark the outside corners of the square hole and the mounting bolt holes. I then drilled them with a 1/4 inch drill and connected the holes with the Dremel to cut out the square. I used secuirity head screws and nyloc nuts for mounting to prevent theft.
I used Cree led lights that look identical to the Rigids shown. More than enough light for backing up.
I highly recommend this mod..
I used Cree led lights that look identical to the Rigids shown. More than enough light for backing up.
I highly recommend this mod..
#33
Senior Member
i did the same mod to my truck, i used knock off rigids i got on amazon for $23 each. The specs on these were exactly the same as the specs for my actual rigids I have in the front... but after installing, they give lots of light, but do not compare to actual rigids.
#34
Senior Member
Awesome job friend! I identical in every way to my truck rear end except the color. ha
Danny
Last edited by dannytexas; 08-28-2015 at 05:23 AM.
#35
I have done the same on my 2014 Screw 6.5 bed. Will post pictures. Well done. I have a switch that allows me to turn them on and off manually. Work great for tailgates as well as backing up.
#37
Senior Member
Hope you and your family are well and thank you for helping keep Dallas safe.
We salute you.
Danny