Ok.....so on my old nissan titan i debadged everything possible....everything was glued or sticky tacked on so it was very simple.....
My question is on my '12 f150 ....can i remove the emblems on the side of the truck and the ecoboost emblems on the side......i know some vehicles are attached with a hole through the body...i dont want to attempt pulling them off if thats the case???

Thanks in advance!!!!

 

Fender ones have the pins, ecoboost no pins

 

Grrrrr...ok thx...any ideas if u want to pull them

 

Probably be costly to remove the F150 emblems on the front fenders and fill the holes, unless you do body and paint work.

 

Dang.....ok thanks for the info!!

 

The f150 badges on the tailgate also have locating holes. Fyi

 

Yeah thanks i figured the giant middle 1 did on the tailgate...damn bad news.......haha

 

All

• all are minimally attached with double-sided tape.

Grille

• 2 nuts
  2 prongs

Fender emblems

• F-150
  2 alignment holes for the F-150 pins and 1 LARGE hole in the middle for venting purposes (?????)

Tailgate emblems

• F-150
  2 alignment slots
  .
• F-150 (on Platinum trim panel) *.below
  2 alignment holes
  .
• Ford oval
  3 alignment holes for pins
  1 LARGE hole in the middle for venting purposes (?????) and/or camera wiring
  .
• FlexFuel
  none
  .
• RaptorSVT
  none
  .
• trim panel (Platinum)
  4 alignment slots
  3 alignment pins
  1 LARGE hole in the middle for camera wiring
  .
• Platinum (on trim panel)
  1 alignment slot

Door emblems

• EcoBoost
  none
  .
• 6.2L (Raptor)
  none

Bed Emblems

• Harley Davidson, Limited, Platinum
  none

 

Can anyone tell me what size the holes behind the fender emblem are? I have an idea how to plug them but need to know what size they are so I can make the plugs.

 

3/8