I just bought a 2014 XLT that did not have a remote start option, I had added this to my 2012 XLT. I have the sensor under the hood of this 2014. I added the antenna and enabled the remote start in forscan in both the IPC and BCM. When I programmed the 2 new keys, the chip was programmed and will start the truck, however, the fob buttons will not work. Any ideas?

 

that tells me that there are already too many fobs programmed to the vehicle

 

I read you can have up to (8) eight. If there are too many how do I kill all but the 2 original Keys. Or ios there a place to reset the number of keys?

 

You can have a total of 8 programmed pats keys but only 4 fobs

 

OK, Is there a way to delete the other 2 fobs as I only have the original 2 keys?

 

you would have to erase all keys and start over

 

All keys or all fobs? If Keys how do you reprogram? If fobs, shouldn't the 8 ignition cycle method, delete the last fob? I have tried the 8 times cycling the ignition and it doesn't work.

 

everything, and no the cycle doesnt wipe them clear

 

Thanks for the replies on this issue. I just Ran thru the fob programing of 8 ingnition cycles and it worked this time. So Iam good to go!