3"-4" lifts
Thread Starter
Lonestar state of mind
Joined: Mar 2014
Posts: 572
Likes: 82
From: Katy TX
Since you have an FX2, I'd take a look at this option as well. The only downside that concerns me is that you are adding 0.5" width on each side
https://www.f150forum.com/f37/maxtra...coming-304945/
I've been on the fence about the RC lift as well, but if all goes right the MaxTrac spindles should be around $500. Add a set of blocks and you should be under $750 total.
https://www.f150forum.com/f37/maxtra...coming-304945/
I've been on the fence about the RC lift as well, but if all goes right the MaxTrac spindles should be around $500. Add a set of blocks and you should be under $750 total.
If you're in the H-town area check out this used set of spindles.
http://houston.craigslist.org/pts/5227829037.html
Brenthel Industries makes them, a little more pricey.. But quality stuff. I would make an offer if I were local.
http://houston.craigslist.org/pts/5227829037.html
Brenthel Industries makes them, a little more pricey.. But quality stuff. I would make an offer if I were local.