Why I only run AudioControl amps...
#11
Senior Member
Thread Starter
Originally Posted by papermaker
So I'm gonna assume you think my thoughts were on the right track.....😬. Now I need to source my amp rack material or find a place that makes them. I see MTI some nice looking ones......
#12
Papermaker24
How do you bend your 1/4" sheets?
#14
Papermaker24
Cool.......that the sheet from Amazon?
The following users liked this post:
FreeMars (10-13-2020)
#16
Papermaker24
On the way......
#17
'19 Lariat 3.5
Are your amps and gear attached with threaded inserts or did you drill & tap the sheet?
#18
Senior Member
Thread Starter
Originally Posted by Gopherboy128
Are your amps and gear attached with threaded inserts or did you drill & tap the sheet?
#19
Papermaker24
Speedwire is large enough to use with the D 1200 or D 800 correct? Any idea what length for SCrew down the drivers side?
Also, I shouldnt have to Forscan anything as far as low level output and convert to RCA but do I need to flatten EQ? Non sony 8" sync 3 doesnt need this if I've gathered my info correctly.
Also, I shouldnt have to Forscan anything as far as low level output and convert to RCA but do I need to flatten EQ? Non sony 8" sync 3 doesnt need this if I've gathered my info correctly.
Last edited by papermaker; 03-05-2019 at 10:17 AM.
#20
Senior Member
Thread Starter
Originally Posted by papermaker
Speedwire is large enough to use with the D 1200 or D 800 correct? Any idea what length for SCrew down the drivers side?
Also, I shouldnt have to Forscan anything as far as low level output and convert to RCA but do I need to flatten EQ? Non sony 8" sync 3 doesnt need this if I've gathered my info correctly.
Also, I shouldnt have to Forscan anything as far as low level output and convert to RCA but do I need to flatten EQ? Non sony 8" sync 3 doesnt need this if I've gathered my info correctly.
Could tell you how much you would need. You will want to grab a tape measure. Make sure to account for 2 runs. From the radio to amp and back.