warriorsfan177

Car audio is my weakness and I have little understanding of it. I'm about to purchase 2 Memphis audio 10's in a down-firing enclosure from a forum member.
It also comes with this amp- "Memphis Audio PR1X600 :: Features# Channels 1 Max. Power Output (Watts) 600 x 1 RMS Power Output (Watts) 180 x 1 Frequency Response 20Hz-250Hz"
I have the factory sony system without nav in my 09 platinum. I know that I will have to take out the old sony sub amp wiring harness because the wiring isn't heavy enough. I have no clue on what wiring I am going to need and which harness i need to buy to make it work. Any and all help is greatly appreciated.

zacharyz

Get an LC6i and take it to a stereo shop.

Windup

The factory sub is powered, if you take the wiring harness before it, it's low level and can go straight into the new amp input. Being low level it doesn't matter if the wiring isn't heavy enough.

Pin 7 is + it is violet / green.
Pin 8 is - it is green / white.

For the remote wire, you can add to any fuse that says radio or delayed.

I have not seen any harness that work with the Sony premium sound.