frank122376

update guys, did the standard bleed after replacing the line the booster and the master, brakes are working perfectly so far, ABS has not worked since i owned the truck so that light is still on, However i am curious to see what this electronic bleed will do. I don't know if i have 4wabs, all i know is it is a two wheel drive truck with rear drums. Im not too familiar with abs systems and how they work in general. I appreciate the insight and thanks to all

RLXXI

Easy to tell if you have 4wabs, the brake lines coming out of the master cylinder would enter a large block (hcu) and you would see a cluster of other brake lines in the same place.
.

frank122376

ok guys ford f150 1999 Tritan v8 4.6l, had an over heat problem and also no heat. antifreeze was low, filled resevoir, no fix, still over heating, changed thermostat, overheat problem fixed but still no heat. flushed heater core, no fix, heat is better but still just luke warm. Is the heater core next?

who_knos

Possible air in system.....I know should self bleed.....or bad head gasket.

frank122376

i was afraid you where going to say that.
Suggestions, if you don't have the time or the resources to change the head gasket

who_knos

You could try to bleed the system many different ways to do it. Most parts stores do sell a deal that uses a color changing liquid to tell if there is exhaust gasses in the coolant.....Lisle makes one and I have used it a few times with good results.

frank122376

new problem, i also have an antifreeze smell inside the cabin? whats the deal with that?

JCR 56

Heater core.