Got your message. Ok, so the VIN is correct in the ABS, so it is programmed to your truck, at least. If they did fully update it, the strategy on your ABS should match one of these file names if you pull up the module details in FORScan.....most likley TDE, but I'm going off memory.



I don't know why your truck is not starting. I am only trying to rule out the ABS not being properly programmed in terms of the firmware and config. I used to be able to see this stuff easily myself, but my access was nerfed. This code below is not normal, but I don't think it would prevent it from starting. I've never had to swap an ABS myself, so not sure if there is some calibration process associated with it after flashing it. I have updated my ABS module and no further action was required, but swapping a new in may have a different process. Honestly, I'm stumped as to why it won't start. Also, either your data sharing to Ford is turned off or your modem has limited connectivity, because I am not able to pull codes or any connected data on your truck.

===ABS DTC C0062:54-AB===
Code: C0062 - Longitudinal Acceleration Sensor

Additional Fault Symptom (:54):
- Missing Calibration

Status (-AB):
- DTC Present at Time of Request
- Malfunction Indicator Lamp is On for this DTC

 

A no start can be caused by a link to the ABS called Electronic Brake by wire (EBB) and ABS Programming.
Possibly the Body Control Module needs to be reset.
Blown 50 amp BBS fuse.
Wire issue.
Good luck.

 

Thats how I knew the old one was bricked, popped both 50A Jcase fises for EBB