So last week I was traveling home and I was unable to accelerate with the truck. I was only able to go about 20 mph. At this point I had no check engine light and no pending codes. I had a friend check it out with there scanner and they said there was no throttle response. So they advised me to change to tps or the throttle actuator control.

So I disconnected the battery and removed the throttle body and cleaned it, replaced the tps and the throttle actuator control. I reconnected the battery and let it relearn the throttle body by turning the key to the on position letting it sit for a couple of minutes and then starting it. It ran for about a 1/2 hour and when I went back out to it the wrench light was on along with the check engine light. It now has the following codes P2104, P2111, P0122, P0222, P0223, P2106, P2110.

I did test that I have 5 volts to the tps. The throttle actuator control will spin when the truck first turns on. I was able to have a helper push down on the gas and watch the throttle plate open and close. Should I have just replaced the entire throttle body or is there something else that I could check ?