Topic Sponsor
2015 - 2020 Ford F150 General discussion on the 13th generation Ford F150 truck.
Sponsored by:
Sponsored by: Worksport

Wheel offsets

Thread Tools
 
Search this Thread
 
Old Dec 17, 2015 | 10:00 AM
  #1  
shore's Avatar
Thread Starter
Senior Member
 
Joined: Dec 2015
Posts: 642
Likes: 61
Default Wheel offsets

3 offsets, which would be preferred to not stick out much? I don't mind a bit for the look. These are the common offsets in the wheel I like.
+0
+18
+25
+30

any pics to show the difference would be greatly appreciated.

Going to run a 33-34" around 11" wide on a leveled 4wd
Reply
Old Dec 17, 2015 | 10:17 AM
  #2  
SilverSurfer15's Avatar
Senior Member
 
Joined: Nov 2015
Posts: 1,050
Likes: 230
Default

The higher the number (positive) the more it will sit inside the fender.

The lower the number (negative) the more it will stick out.

You are going to want 0 or 18, the other two are going to sit inside the fender and look pansy IMO. From what Ive seen, even the 12 and 14 inch wheels dont sit THAT far out from the wider fenders on the 2015s. I would probably get the 0, but it WILL toss some dirt up on the side of the truck. The 18s are probably the best at being "even" with the fenders, without looking tucked inside.

But without seeing enough of these in person, its hard to be 100%. You need a lifted guy to chime in.
Reply
Old Dec 17, 2015 | 10:19 AM
  #3  
shore's Avatar
Thread Starter
Senior Member
 
Joined: Dec 2015
Posts: 642
Likes: 61
Default

Lots of info out there but ti gets confusing with tire/wheel width. Add in the choice of going terra graps G2/wild peak AT/toyo AT.
Reply
Old Dec 17, 2015 | 10:21 AM
  #4  
SilverSurfer15's Avatar
Senior Member
 
Joined: Nov 2015
Posts: 1,050
Likes: 230
Default

How far out do you want the tire?
Reply
Old Dec 17, 2015 | 10:27 AM
  #5  
shore's Avatar
Thread Starter
Senior Member
 
Joined: Dec 2015
Posts: 642
Likes: 61
Default

I don't mind a little. Not wanting crap thrown up on the truck in a big way. This is my F250. This was probably too much.
Attached Thumbnails Wheel offsets-f2501.jpg  
Reply
Old Dec 17, 2015 | 10:27 AM
  #6  
SilverSurfer15's Avatar
Senior Member
 
Joined: Nov 2015
Posts: 1,050
Likes: 230
Default

loook through this, there a bunch of pics. He thinks they are +20, but never says for sure. PM if you want, but they look like +20 to me as well. an 11" wheel at +18 would probably be ~1/4" outside the fender more than his? maybe closer to a 1/8".

https://www.f150forum.com/f118/my-le...atinum-289542/

He also has 35s though. With a smaller tire, it would look better being a little further out.
Reply
Old Dec 17, 2015 | 10:28 AM
  #7  
SilverSurfer15's Avatar
Senior Member
 
Joined: Nov 2015
Posts: 1,050
Likes: 230
Default

also read this....

https://www.f150forum.com/f118/20x9-...offset-296694/


its not 100% apples to apples if the wheel widths arent the same, but its close enough.
Reply
Old Dec 17, 2015 | 10:30 AM
  #8  
SilverSurfer15's Avatar
Senior Member
 
Joined: Nov 2015
Posts: 1,050
Likes: 230
Default

If that pic you posted is too much, the 18s would probably be best. I think the 25 would be too far in. Unless you went to a 35.
Reply
Old Dec 17, 2015 | 10:33 AM
  #9  
shore's Avatar
Thread Starter
Senior Member
 
Joined: Dec 2015
Posts: 642
Likes: 61
Default

That platinum looks ideal and has the falkens, they look very good on it.
Reply
Old Dec 17, 2015 | 10:36 AM
  #10  
SilverSurfer15's Avatar
Senior Member
 
Joined: Nov 2015
Posts: 1,050
Likes: 230
Default

You might want to change your wheels to 20x9 then... for simplicity lol.
Reply



All times are GMT -4. The time now is 08:12 PM.