What did you do to your truck today?
#8961
Senior Member
Weather Tech Tailgate Guard.
The following 3 users liked this post by 2AF150GA:
The following users liked this post:
blkZ28spt (04-05-2020)
#8963
Senior Member
Funny, I have the exact same weathertech tailgate guard and Rough Country bed mat combo!
And I have a stick on tailgate gap filler. With a soft tonneau cover.
I did use a foam seal on the tailgate to bed gap because I was still getting dust blowing in under the tonneau.
And I have a stick on tailgate gap filler. With a soft tonneau cover.
I did use a foam seal on the tailgate to bed gap because I was still getting dust blowing in under the tonneau.
The following users liked this post:
2AF150GA (04-05-2020)
#8964
Senior Member
I just installed a 4' Firestik on a Firestik offset stake bed hole mount in my rear right stake hole. How did you route your antenna cable? Possibly pictures?
My plan is to use self stick cable clips along the inside bed wall to the front wall plastic plug and forward of that I haven't decided.
My plan is to use self stick cable clips along the inside bed wall to the front wall plastic plug and forward of that I haven't decided.
Last edited by Boomerweps; 04-05-2020 at 04:39 PM.
#8965
relocated my Air Lift controls to the bed tailgate area. to me, JMHO, it made zero sense to have the control inside the cab. when I need to level the truck, I would constantly go back n forth to the cab to add more air or let some out, until the truck looks level. now I just need to stand by the bed to do it. heck I might even swap the manual add-air switch for a 12v bluetooth switch and do it from my phone while I'm standing back a few feet from truck. lol
depth of tailgate area is perfect. i had to drill three 1/2" holes behind the control set. two holes for air lines and one hole for switch wires. this lets the control panel sit flush.
easy to run wires down to underside of bed, to compressor location, by removing the tail light. plenty of room.
depth of tailgate area is perfect. i had to drill three 1/2" holes behind the control set. two holes for air lines and one hole for switch wires. this lets the control panel sit flush.
easy to run wires down to underside of bed, to compressor location, by removing the tail light. plenty of room.
Last edited by LA_F150; 04-05-2020 at 05:36 PM.
#8966
Senior Member
iTrader: (3)
Cleaned it up a little, installed my Console Vault, lined it with speaker box carpeting and switched my visor for one with Homelink.
#8967
Senior Member
Funny, I have the exact same weathertech tailgate guard and Rough Country bed mat combo!
And I have a stick on tailgate gap filler. With a soft tonneau cover.
I did use a foam seal on the tailgate to bed gap because I was still getting dust blowing in under the tonneau.
And I have a stick on tailgate gap filler. With a soft tonneau cover.
I did use a foam seal on the tailgate to bed gap because I was still getting dust blowing in under the tonneau.
#8968
#8969
Senior Member
I added the PRNDM light to the console on my 2020.
The following 6 users liked this post by NASSTY:
2AF150GA (04-05-2020),
jcfountain33 (04-05-2020),
JeffG1216 (04-13-2020),
johnday in BFE (04-05-2020),
soaringfalcon (04-07-2020),
and 1 others liked this post.