I just swapped out the 4" radio to the 8" touchscreen. While changing from the single usb to the double usb in the center console, the door got stuck and then what looks like a flat, thin coil spring went flying off. I'm not sure where it goes, but my sliding door is fully manual now.

Does anyone know where this thing belongs and how to put it back on?

 

Hope this helps. I have a spare door too. Let me know if you want to see the under side of the door. I can take a photo.



Mike

 

Thanks for the pic Mike! I don't see that spring in the photo though, I have no idea where it came from when it flew off. It stretches out to about 6".

 

Ok that helps...Here is where it goes I think. This is looking at the bottom. This one is has some grease on it so it looks sort of funny. You are probably going to have to remove the console top trim panel to put it back in.




Mike

 

Oh ..It will stick and you have to force it a bit to make it work right if the part is tipped upside down, I though the Raptor CF one pictured above was broken at first. I force it open then closed and it started working fine. Tipped it upside down again and it stuck until I forced it closed and back open.

Mike

 

Does it actually connect to anything? I don't remember seeing the plastic piece either, hopefully its still there. I appreciate the help, I haven't found a thing about it on the web.

 

When you actuate the door it winds and unwinds. The white plastic piece snaps on and off. I didn't take it off because I don't know how hard it is to get it back on.

Mike

 

Here is a picture of one end when the door is fully opened an locked. The spring is unwound.

 

 

haha...fixed...should have been ...SOME

Mike