Show me your bed toppers (camper shells)!
#502
There you go ARE MX Cap with side windoors. Love it got storage/tool boxes on side for easy access
The following users liked this post:
MeatWagon17 (04-28-2017)
#504
Very nice, thank you! I should have mine on by now but i boogered up my back really bad and had to cancel my install appointment on Wed as I couldn't sit down without severe pain and it was a 2 hour drive. Hopefully by next week I can go get it. Looks great with your gray truck. Hoping mine looks just as good. For some reason I have a picture of a beluga whale in my mind because my truck is white ! Lol
The following users liked this post:
Zremac (04-29-2017)
#505
I've been debating wether to go with a standard height (Z series) or a higher rise (MX series).
I'm also planning on buying the racks on top, so your setup look really like what I'd like...
I think the increase inside height must be very interesting but I was afraid that the "look" of the truck would suffer...
And if possible, can you measure the full height including the bars on top ?
Thank you for your time!
The following users liked this post:
Zremac (04-28-2017)
#508
Very nice, thank you! I should have mine on by now but i boogered up my back really bad and had to cancel my install appointment on Wed as I couldn't sit down without severe pain and it was a 2 hour drive. Hopefully by next week I can go get it. Looks great with your gray truck. Hoping mine looks just as good. For some reason I have a picture of a beluga whale in my mind because my truck is white ! Lol
I think it did more masculine look, love practicality of it for work and play. I did seen white on a job side like mine and did look great.
#509
Would you be kind enough to post more picture of your ARE MX on your truck ? Various angles, front, sides, back, with the back door open, etc.
I've been debating wether to go with a standard height (Z series) or a higher rise (MX series).
I'm also planning on buying the racks on top, so your setup look really like what I'd like...
I think the increase inside height must be very interesting but I was afraid that the "look" of the truck would suffer...
And if possible, can you measure the full height including the bars on top ?
Thank you for your time!
I've been debating wether to go with a standard height (Z series) or a higher rise (MX series).
I'm also planning on buying the racks on top, so your setup look really like what I'd like...
I think the increase inside height must be very interesting but I was afraid that the "look" of the truck would suffer...
And if possible, can you measure the full height including the bars on top ?
Thank you for your time!
Cap is more practical for work and play. I can fit easily dryer, washer, or 5 Ton 16 seer AC condenser or anything bulkier like sheet metal fittings or black iron duct fittings
As of roof racks I notice some mpg loss if i keep them on but is very minimal like .5mpg at tops
as of hight its like 83'' plus 2" for rucks.
I had overland on my previous truck and i found it is less functional due to door opening and each time i had to crawl on my 4 to get something now basically i can walk in inside without using my knees and with 156 WB looked kind longer and with out roof rucks looked like a bus.
Last edited by Zremac; 04-29-2017 at 12:59 AM.
#510
Senior Member
Ordered a CX this morning. Will post pics when it arrives. I've had the Z series and a V series. The Z was horrible. That non framed back glass leaked and chipped on the edge. The V was ok but I didn't like the cheaper look of it compared to the CX.