Canadian F150 Owner

I will take a picture tomorrow, I do not have the sun roof so I might be able to provide you the details and measurements if that helps.

KustomFX

iTrader: (3)

Sounds good. If you're comfortable enough, I'm assuming it (overhead lighting/sunglasses holder) attaches the same way as the other trucks,..pull it down and take a peak at the sensors too.

The OP (El Matador) does not have sensors, and also No power slider & found out his head liner is shaped slightly smaller than the ones I've seen. So his input & help on the R&D had been incredible help!!

I'm going to a larger dealer over the weekend to see in person to finalize all headliner configurations before it's "on the market" for sale. I need & want to know all the facts so I have answers to any questions & options.
Again, I can't thank J (El Matador) for all his help in the pre-release of these switch panels. His pics will be used in the installation instructions and will most likely be "typical steps"in all the trucks that these work in.

Please Feel free to email me directly at lethalweapon09@yahoo.com and I'd love to see what you have. I think you're going to be fine if you don't have the moon roof.

Here's a pic of one without the inside motion sensors:

ThatNewWifeSmell

Nice and clean install OP and KustomFX.

Someone mentioned switch panels with a sunroof. The 2017 Super Dutys have overhead switches that should retrofit to F150s if someone needs more switches.

LMychajluk

+1 for interest in a solution for a Platinum w/ Moonroof. Overhead panel would be nice, but not stuck on it.

KustomFX

iTrader: (3)

Thank you! I appreciate it.

I saw those while I was at the dealer getting my initial measurements and templates for the F-150. (The salesman took me over and showed me a $70k F250 that had them in it)
That is a Very nice set up!!!
Not sure if it's compatable or not...but it really is nice and would be a great option if it would work!

Methos000

iTrader: (1)

That looks awesome to me also. I've got a 2017 Platinum on order and this looks like an accessory that would appeal to me. Subscribing to this thread.

LMychajluk

The OEM Overhead console from a 250 or maybe a Raptor might work. Thought is that the '17 F150 may even have the wiring harness already in the truck for the Aux switches, though that's not confirmed. The '15 & '16s probably don't, and you'd have to rig up some type of harness.

El Matador

Thanks! Though it was really all KustomFX's doing. I was just a dude with a dremel

KustomFX

iTrader: (3)

Thank you! But your the very first person to have one & you took the plunge to help me with the final R&D on the completion of these for the 13th gen trucks.

So I personally thank you for the install and your personal input ... plus all the great pics for finalizing the instruction sheet that will be for the 2015-current F150 trucks.
Again, awesome & clean install ....& I know pics don't do it justice!

Thanks & enjoy the new truck too!!!

KustomFX

iTrader: (3)

These will be for sale publicly soon!!
Instructions are now done & have a few switch panels lasered with the new 13th gen F-150 logo, the FX4, Sport, among a few others....

These will NOT fit moon roof equipped trucks. There simply is no room.
More to come in the classified section soon!

Pics:










The plastic support MUST be dremeled for these to fit: