BLIS modules help needed
Thread Starter
5 Year Member
Joined: Jan 2013
Posts: 849
Likes: 142
From: Northeast Texas
BLIS modules help needed
Long story short, I’ve got a ‘17 with LED/BLIS tails and upgraded to a pair of Raptor tail lamps but didn’t realize they were off an ‘18 Raptor. Didn’t include modules, so went to swap my modules over and the BLIS plugs are different. SO before I cut up two pairs of lights to swap pigtails, does anyone know if ‘18 modules will get a long with the 15-17 trucks? I’m fine with a re-flash if that’s what’s needed at the dealer, but would rather know they’re good before I purchase a pair...
Thread Starter
5 Year Member
Joined: Jan 2013
Posts: 849
Likes: 142
From: Northeast Texas
The pin configuration is the same, but the ‘17 tails have a tab that runs the length of the connector above the row of pins I’m assuming for alignment purposes whereas the ‘18 tails just have the row of pins/female recepticals. Either I’ll trim the tab down enough to mate the pins of just swap ends on the tails, but I would have liked to keep the ‘17 tails together for an easier sale
Senior Member
Joined: Apr 2016
Posts: 338
Likes: 64
From: Kansas City
Long story short, I’ve got a ‘17 with LED/BLIS tails and upgraded to a pair of Raptor tail lamps but didn’t realize they were off an ‘18 Raptor. Didn’t include modules, so went to swap my modules over and the BLIS plugs are different. SO before I cut up two pairs of lights to swap pigtails, does anyone know if ‘18 modules will get a long with the 15-17 trucks? I’m fine with a re-flash if that’s what’s needed at the dealer, but would rather know they’re good before I purchase a pair...
I just need to make Bit changes with Forscan and added the tail light wire harness JL3Z-13A409-G for XLT and for Lariat and above JL3Z-13A409-C
Last edited by Coola1; Mar 21, 2019 at 12:46 PM.
5 Year Member
Joined: Dec 2018
Posts: 144
Likes: 25
Yes I installed 18 LED tail light with Blis modules in the On my 2015 XLT and programmed them. They work just fine on my 2015. Lights and Blis working all ok.
I just need to make Bit changes with Forscan and added the tail light wire harness JL3Z-13A409-G for XLT and for Lariat and above JL3Z-13A409-C
Is the JL3Z-13A409-G harness if you have 15-17 and want to upgrade to stock LED tails or will they work for my 18 xlt converting to stock 18 Blis LED’s
Senior Member
Joined: Apr 2016
Posts: 338
Likes: 64
From: Kansas City
The harness of JL3Z-13A409-G should work for your 18 Led tail light upgrade, this is an 18 year harness as designated by the J at the beginning.