I've looked at several threads on this topic but I'm not finding an answer to my question. My camera is not showing the backup guidelines. It has come on a couple of times. It is a factory camera on a 2019 Lariat. I purchased a new OEM camera and replaced it, but it still does not show the lines. I currently see a perfectly clear picture, and the prox sensor display. I have gone into Forscan and run the rear camera calibration, which it completed, but still no guidelines. Is there something else I can look at in Forscan to determine if settings are correct?

 

https://www.f150forum.com/f118/backu...elines-510633/

Post number 3.

 

Also in the 19, can the lines be turned off in SYNC?

 

Thanks for that info. I ran the BdyCM LIN calibration, and the IPMB LIN, and the BdyCM Rear Camera calibration. All of them were successful, but still no guidelines. Is a calibration the same as a "reset"?

 

Where did you purchase the replacement camera from?

 

Although now that I look at the rest of the data from Forscan, I have codes associate with the camera moduleI'm totally new to Forscan, trying to figure it all out. It almost looks like there was some configuration that was not completed on Module B, perhaps that is the root of my problem??

 

From the Ford Dealer.