I disabled the Auto Start/Stop feature in my 2017 by pulling the brake position sensor connector up under the dash. In 2017 it was white. Picked up a 2020 recently and wanted to do the same, but at my age I could not get a good enough look to do the same in the 2020. It is now black, and I could not find the tab that might release the connector. Does this method still work in 2020 to disable the feature? Any suggestions on pulling the connector? I tried to take a pic with phone, but it's a little blurry and I do not currently ahve a way to post.

 

Remove the 4-pin connector on the trailer module just like your old truck, there is only one 4-pin on the box. I did it on my truck until I got the Auto start stop eliminator. If you tow be sure to plug it back in.

https://www.f150forum.com/f118/disab...econds-406110/

 

Got it, just hard to see up there with my 74 year eyes. Just never got back to the internet to report.

 

Yup, the clip is a bit finicky, I try and be gentle with it, hoping I never damage it.