6" lift w/ 35's cab height
#2
Senior Member
How tall is your garage? I doubt it unless you have a non typical opening. Just installed a 4" lift on 35s and cab height is right at 83"...barely squeaked in.
#3
My garage is 83" but fxf-150 has a bds 4" with 35's and says his measures 80". Is your truck level front to back with the 4" or higher in the rear?
#4
Senior Member
Interesting. It's a zone lift (basically same lift as BDS owns Zone and I compared the 2 when researching) and has a 4" block both front and back with about 1 3/8" rake. I could see how a 3" block for me in the rear would lower it, but not to 80". My fender measurements are: Front: 42 5/8" Rear: 44" I have not actually run a level off the side of the high point of the roof and measured. Just based the height from the clearance at the door opening which I know is 84".
Last edited by DWSmoot; 01-09-2016 at 09:13 PM.
#5
Interesting. It's a zone lift (basically same lift as BFS owns Zone) and has a 4" block both front and back with about 1 3/8" rake. I could see how a 3" block for me in the rear would lower it, but not to 80". My fender measurements are: Front: 42 5/8" Rear: 44" I have not actually run a level off the side of the high point of the roof and measured. Just based the height from the clearance at the door opening which I know is 84".
#6
Senior Member
Pretty sure he has the same set-up as me on the 4" front and rear. We connected thru PM prior to me getting my lift. Something seems off though for me to be 3" higher. I will run out to the garage and re-check the door measurement again to be sure. Stand by...
#7
Senior Member
Actually had it wrong, sorry for the wrong initial information. Weatherstrip height is right at 81-1/4". That would make my truck height around 80-1/2".
Last edited by DWSmoot; 01-09-2016 at 09:36 PM.
Trending Topics
#9
Senior Member
Not sure I am going to change it. I have always had my trucks level but I sort of like the slight rake. Do you have a 3.5"? I think if I change it thats what I will go with. Really just have not been able to locate one.
#10
ready lift use to make a 3.5 add a leaf block combo its in stock in my local warehouse but i think its a 4.5. part number 26-2104