What did you do to your truck today?
03-07-2011, 08:04 AM
#45
Junior Member
Join Date: Oct 2010
Location: ohio
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
well it wasnt today, but last week when it was in the shop, I replaced the steering box. no power steering. installed my cb in it finally, new poineer radio i bought from feezles autp wrecking, pioneer speakers. gotta buy a bug guard, 3 inch suspension lift, new flowmaster exhaust, diamond plate bed rails, and put 35's mud kings on her. its lookin bad ***.
03-07-2011, 09:21 AM
#46
Senior Member
Thread Starter
I need to drain and fill my transmission too. I did it last year, but since then I haven't even looked at it.
Last night I reinstalled the egr system the p.o. took off. New vac can, egr solenoid, vac lines, and some elbow grease. I have a few kinks to work out, but I'm hoping I can gain an mpg or two having some of this stuff working again.
Last night I reinstalled the egr system the p.o. took off. New vac can, egr solenoid, vac lines, and some elbow grease. I have a few kinks to work out, but I'm hoping I can gain an mpg or two having some of this stuff working again.
03-08-2011, 02:11 AM
#49
Senior Member
Join Date: Feb 2011
Location: Louisville, KY
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
Just doing some routine inspections had the truck about a week had some break squeals decide to take a look and see what condition they were in and replace a broken off wheel stud while i had if off the ground found i had bad upper and lower ball joints on the passenger side 43 dollars later upper and lower ball joints two wheel studs as the idiot p.o. cross thread the one as well broken on off after futher inspection was due to being cross thread shes good to go a couple more inspections and some money saved up she will be ready for new tires and rims
