Hello to all, I hope I am in the right spot, if not I do appoligize. I am currently working on a 1996 F150 with a straight 6, It has been over heated and has some issues, however it has good compression, I have replaced radiater, surp. belt, water pump, spark plugs, wire, cap and bug. I have good fuel presure, both pump is working. I have spark to all 6 plugs, wires, coil, cap. I have a truck that will turn over but will not start not even on starter fluid. Any help would be great. Also a friend is going to let me use his dionostic machine where does one plug this in at? I have not found a plug in port? Thank you in advance.
P.S. I have searched trying to find a thread on here simular but have not had luck.

 

Is it not under the dash? Try on the fire wall in the engine compartment for the hookup for the code reader

 

turns out the distributer was fried. Just a lesson to make sure you inspect your equipment .

 

I got a 94 f150 two wheel drive that has totaly floored me. It has a mis under a load, I have checked the inj. the fuel rail, fuel pump, fuel filter, map senser, temp sencers, speed senser, fuel presure, 02, ign. (coils, box, wireing, ext.) All ground wires, alternator, battery, egr valves. Anyone that has an ideal let me know.
I also want to take the time to let everyone know that I have been gone for quite sometime and I do appologise for my absents.

 

Does it loose coolant, have sweet smell at exhaust. Head problem!