Thought this would be helpful!

1. Turn ignition to RUN or ACC.

2. Momentarily jump pins in programming connector located at the base of the steering*
column. All doors will lock then unlock to confirm programming mode.

3. Press any button on first keyless remote. Door locks will cycle to confirm programming.

4. If programming a second keyless remote, press any button on second keyless remote.
Door locks will cycle to confirm programming.

5. Turn igniton to OFF. Locks will again cycle to indicate end of programming mode.

 

Can someone explain what step 2 means?

 

There is a gray two pin plug behind the dash, behind the cubby hole to the right of the steering wheel. These are the pins you will want to "Jump". The modules located with it are the remote lock modules.