after replacing the wires behind my dash to get the tail lights to work. put the dash back up( didnt reintall it, just mock up). i try and start the truck. i trace down the ignitions wires. red with light blue strip, green, and green with white strip to the Ignition control modular. the wires look fine. so time for a lil testing. after using a jumper wire on the plug that goes to the clutch master cylinder. i use the jumper wire to from red, red w/lit blue, to green w/white. i push the break pedal and the truck starts jumping forward (it was still in gear). now this will happen even with no key in at all. so am i looking at replacing the ICM? cause i break lights so i dont see why the sensor that i mounted above the pedal would have anything to do with this.

http://www.flickr.com/photos/51461215@N06/7557961688/http://www.flickr.com/photos/51461215@N06/7557961688/ by http://www.flickr.com/people/51461215@N06/, on Flickr

 

What did you do? Hook the brake lights to the start wire?

 

the green w/white is no the brake wire per say, it runs from there with both the red w/lit bl to the ICM.

 

Your melted wire issue probably fused two wires together.

 

i couldnt find anymore wires melted together. but then again no telling how much more of the wires behind the dash i needed to replace. but i replaced all i seen. i didnt take the wires all the way to the ICM stoped when i stopped finding melted wire. called it a day

 

also this didnt start happening till after i pulled the dash forward. i didnt take it all the way out. just a nuff so it laid on the front of the seat. just a nuff for me to get back there and start tracing wires