hello i have a 1992 5.0 ext cab f150 and i am wanting to switch it to manual from auto. i picked up a zf5 S5-42 with clutch and flywheel from a 1992 f350 with a 5.8 i am wondering if any one has any helpfull information for doing the swap. any help is appreciated

 

You will need the pedals, column, master, line, ecu from a 92-96 150-350, also need harness for neutral switch. And make sure the flywheel has the same imbalance as the 302 you are putting it behind, most later yrs use a 50oz flywheel, research and make sure the 351 flywheel will work on the 302.

 

i am getting a ecu from a mustang ......... whole reason im doin this swap is so i can convert to maf

 

Didn't they put automatics in mass-air motors???

 

Yes they put maf in autos, alot of crown vics have them also. Be careful of the computer unless you are changing the complete harness, obd1 and obd2 harnesses are different at the ecu.

 

...just playing devil's advocate. Seems like this is a long walk down a short pier to do a MAF conversion?

Why not check with these guys?
http://www.mass-air.com/Products.htm

 

Hate to refer to another forum, but fullsizebronco.com has several very good write-ups on this. Check it out.
http://fullsizebronco.com/forum/show...l+transmission

 

Alien startin trouble already,

 

i am changing the complete harness and i woulda liked to keep auto but i have 2 e40d trannys and it woulda been alot harder to find the ecu for it so i just talked to my buddy n picked the manual for 100$