Pulled out coin holder
#1
Dazed and Confused
Thread Starter
Pulled out coin holder
Have a 2011 XLT SCrew and was thinking of installed a voltmeter where the coin holder is. I pulled it out and saw this connector attached to the back of it. Does anyone know what it is for?
The following 5 users liked this post by dejong1:
Al Czervik Construct (02-05-2024),
crazydubc (02-16-2015),
drboyddrboyd (02-15-2020),
gtguyonli (05-08-2014),
smann93 (11-01-2014)
#6
First Tiger of G.R.O.S.S.
I have a floor-shifter for my 4x4 so I get "best of both worlds"... 4x4 AND a coin holder :P
Actually interested in putting a voltmeter there too... anyone know the pinouts of that harness? I assumed at least one of them is lighting wire, one is a ground wire... if there is a 12+V in there it may save some wiring headaches to me and the OP.
Actually interested in putting a voltmeter there too... anyone know the pinouts of that harness? I assumed at least one of them is lighting wire, one is a ground wire... if there is a 12+V in there it may save some wiring headaches to me and the OP.
#7
Dazed and Confused
Thread Starter
I would think there is power. I am going to test it and see what I come up with.
Trending Topics
#8
I have a floor-shifter for my 4x4 so I get "best of both worlds"... 4x4 AND a coin holder :P
Actually interested in putting a voltmeter there too... anyone know the pinouts of that harness? I assumed at least one of them is lighting wire, one is a ground wire... if there is a 12+V in there it may save some wiring headaches to me and the OP.
Actually interested in putting a voltmeter there too... anyone know the pinouts of that harness? I assumed at least one of them is lighting wire, one is a ground wire... if there is a 12+V in there it may save some wiring headaches to me and the OP.
The following users liked this post:
MyDesiredName (01-09-2021)