Pulled out coin holder
Have a 2011 XLT SCrew and was thinking of installed a voltmeter where the coin holder is. I pulled it out and saw this connector attached to the back of it. Does anyone know what it is for?
https://www.f150forum.com/members/ta...coinholder.jpg |
This is for the switch on a 4x4. The wiring harness is the same.
|
gotcha....thanks
|
I came in here to figure out where the coin holder was....
Realized that I couldn't have a coin holder because i have 4x4... Good trade! |
just do the 4x4 mod...
put a 4x4 switch on their and enjoy your 4 wheel drive truck... :party: |
Originally Posted by eclark53520
(Post 831231)
Realized that I couldn't have a coin holder because i have 4x4...
Actually interested in putting a voltmeter there too... anyone know the pinouts of that harness? I assumed at least one of them is lighting wire, one is a ground wire... if there is a 12+V in there it may save some wiring headaches to me and the OP. |
Originally Posted by dejong1
(Post 831244)
just do the 4x4 mod...
put a 4x4 switch on their and enjoy your 4 wheel drive truck... :party: I would think there is power. I am going to test it and see what I come up with. |
Originally Posted by Hobbes80
(Post 831245)
I have a floor-shifter for my 4x4 so I get "best of both worlds"... 4x4 AND a coin holder :P
Actually interested in putting a voltmeter there too... anyone know the pinouts of that harness? I assumed at least one of them is lighting wire, one is a ground wire... if there is a 12+V in there it may save some wiring headaches to me and the OP. |
Originally Posted by Tallyman89
(Post 831296)
Exactly what crossed my mind when I was told it was for 4X4. Just install the switch and I have 4X4 right??? :jester:
I would think there is power. I am going to test it and see what I come up with. |
|
All times are GMT -4. The time now is 08:35 PM. |
© 2024 MH Sub I, LLC dba Internet Brands