MaxOhms

Howdy folks!
We are getting 36psi at the rail.
We have power full time to the injectors.
There is no pulse/connection from the ground wire to the injectors (tested only one, but there is no attempt to fire except with starting fluid)
The truck was running good and would die occasionally at idle or moving.
Until now, it would start again in a few minutes or so.
Now it will not start.
Thanks in advance.

Just got it to run a few minutes (up to op temp 0 and ran the codes.

It is showing:

- P0320 Ignition/Distributor Engine Speed Input Circuit (Pending)

-P1351 Ignition Diagnostic Monitor Circuit Input Malfunction (Pending)

The Check Engine Light is NOT coming on.

Signed,

Bewildered, Perplexed, Humbled, Stressed, Confused, Stupefied, & Just Generally Ticked Off

Aktech

I`m not sure what you mean by pending. I guest I`ll wait to.

MaxOhms

That's what the (borrowed) scanner said.

I have no Idea what it means either.

I'm sure hoping someone will come along here and shed some light on this.

Thanks for waiting with me.

Aktech

I`ll look more in to it after work tomorrow.

techrep

iTrader: (1)

pending means it was not complete after engine was started up...did not run long enough

MaxOhms

We had just put a new (reman) distributor on it and read on here yesterday that they tend to have bad PIP's (stators) on them.

The symptoms sound like that may be it.

That is a cheap part to throw at it, so will do that today.

Will let all know the outcome.