I did not want this to be my first post.

95 f150 2wd, auto, 5.8l.

New front end.

Tonight I changed the front pass side wheel bearings snd seal and now Im getting a ABS light? I took everything back apart and it all looked fine, still an ABS light. So, I thought it only had ABS in the back?? Im lost.

Thank you in advance.

 

I believe theres a ABS sensor on that ...did you disconnect a wire while doing the bearing..

 

No sir. I even went back and tore the whole thing apart and everything. Id done my front end a week earlier and had zero problems, now this.

Ps: i noticed my e brake light wasnt coming on even though the brake was engaged, when i disengaged it flickered a little, if itd been daylight i wouldnt have seen it.

 

not sure if a 95 has a speed sensor or not for the rear..maybe somebody with more knowledge will chime in...

 

Nothing for ABS on the front end. Its a simple system for the rear wheels only. You have an ABS control module (computer), a hydraulic unit (driver frame rail just below your feet) and a rear end speed sensor (top of rear end pumpkin). Probably just a coincidence that it failed after you worked on it. Check your brake fluid level, if you have a small leak and your fluid is low you will get a light, otherwise it is one of those parts/wiring. Check all your fuses also.