Will not Crank? Help please
#11
#12
Since you did the Starter it should be fine, along with the battery and the cables. Test the relay and also inline fuse links ( 3) ? If all good loosen the starter and wiggle it or take it out and use a large screwdriver and move the starter ring gear some. It may be rounded off teeth locking things up. Look in 3 spots on the ring gear for damage with a good flash light.
You may not have all the cables hooked up correctly. One hanging loose ?
You may not have all the cables hooked up correctly. One hanging loose ?
#14
problem solved.
i found a ground wire tied into the pos lead on the starter, i think the person who had the truck before me did it. and when i cleaned the ned lead on the battery post it made the problem worse. i also found the clutch engagement switch is jumped, so i think that is bad too. when i removed the neg lead to the starter it cranked right over like a champ. i dont know why they did that but it was a pain in the ***. LOL thank for all your help everyone i really appreciate it.
#15
The clutch switch can be a real PITA in a storm at night. LOL. Glad your going again.
The following users liked this post:
guyandhistruck (04-16-2014)
The following users liked this post:
guyandhistruck (04-16-2014)
#17
Question is it a manual or auto? I could be the neutral safety switch on theauto or the clutch position sensor if it is a manual I would also check the pedallinkage under the dash there are nylon busing and if that deforms that maycause a no start to.