Starting A Quad-BiXenon Retrofit Build - Looking for Guidance
#1
Senior Member
Thread Starter
Starting A Quad-BiXenon Retrofit Build - Looking for Guidance
Has anyone else done a quad bi-xenon retrofit on their F150 before?
I'm planning to retrofit into the Anzo U-Bar Headlights with the following gear:
Evo X-R (inner)
MH1 - Outer
Diode Dynamics Switchback Set (u-bar LED upgrade)
XK Glow Sequential LED Strip (Across middle part up into side reflector area)
3157 Switchback Indicators
I MAY opt for some switchback demon eyes since there won't be any angel eyes on these (no room), but I am undecided on that so far.
I really don't care about RGB, I am going for an OEM look here.
Just looking for anyone with some experience that might be able to tell me exactly what I am in for.
I've got the U-Bar assemblies and have opened them and have a fairly solid plan of how I am going to do the retro, but then you know, the best laid plans of mice and men.
I'm ordering the projectors Wednesday to get started on the mount, then I'll order the HID systems (I have a 12v power supply ready) to fine-tune the mount positioning and bulb position for the best line-up of the cut-offs.
The rest is just icing I suppose.
Can anyone throw in a few words of wisdom before I dig in deep?
I'm planning to retrofit into the Anzo U-Bar Headlights with the following gear:
Evo X-R (inner)
MH1 - Outer
Diode Dynamics Switchback Set (u-bar LED upgrade)
XK Glow Sequential LED Strip (Across middle part up into side reflector area)
3157 Switchback Indicators
I MAY opt for some switchback demon eyes since there won't be any angel eyes on these (no room), but I am undecided on that so far.
I really don't care about RGB, I am going for an OEM look here.
Just looking for anyone with some experience that might be able to tell me exactly what I am in for.
I've got the U-Bar assemblies and have opened them and have a fairly solid plan of how I am going to do the retro, but then you know, the best laid plans of mice and men.
I'm ordering the projectors Wednesday to get started on the mount, then I'll order the HID systems (I have a 12v power supply ready) to fine-tune the mount positioning and bulb position for the best line-up of the cut-offs.
The rest is just icing I suppose.
Can anyone throw in a few words of wisdom before I dig in deep?