Alright, I've done a bunch of reading up and am getting psyched to do the retrofit. The last straw was my drivers side pNp bulb quitting for no reason. I had a spare that I'm running right now, but I'm over it. Need 6 strips of Switchback LEDs 6" long (3 for each side) and I'll be set. Found these. I could wire them to where the white is on with running lights, then only amber with turn signals. Right?Anyone have the schematic for our turn signal wiring? If it's Running light/Ground/Turn then I can have the white wired to running/ground and amber to turn/ground.http://www.ebay.com/itm/like/141092832854?lpid=82http://www.ebay.com/itm/2-WHITE-12V-15CM-6-Inch-LED-STRIP-9-LED-2-Piece-Kit-NON-Waterproof-USA-Seller-/141094207182?_trksid=p2054897.l4276There's these on amazon also. I would just trim them down, unless it's possible to cut the 30cm in half and have two usable 15cm lights Thinking of doing something like this, but with the ambers working as turn signals and white as running lights.