Load Resistor delete?
#1
Senior Member
Thread Starter
Load Resistor delete?
Thinking about deleting my load resistors and deleting hyperflash via ForScan. I have the load resistors from VLEDs which have a round screw together "plug" with 2 prongs (like the connectors to the ballests on LED headlights). Instead of ripping the resistors out, just in case I gotta go back to them......I was wondering if I could just undo these connections and "cap" them off?
Does anybody sell a sealed cap to go over the male and female ends of these connectors? Then I could just tape the wires up and out of the way.
Does anybody sell a sealed cap to go over the male and female ends of these connectors? Then I could just tape the wires up and out of the way.
#2
Junior Member
I haven't used the VLED resistors myself, but I can picture what you're saying. Could you just pull it off, put a ziploc/sandwich bag over it and throw some electrical tape on it?
If you can disconnect the actual resistor portion and cap it then it will be eliminated from the circuit.
If you can disconnect the actual resistor portion and cap it then it will be eliminated from the circuit.