Laxman09

I have an LED light bar on the way and it comes with a pre-made wiring harness that looks pretty easy to install. The only downer is that switch is not what Id want to install, Id like to use a rocker off OTRATTW. Has anyone done a switch like this before/is it even possible?

LED bar I purchased.

2010_FX4_Lux

The switch is not likely to be hard-wired so simply disconnect the terminals and install on any switch you like. If by chance it is hard-wired or if the terminals don't match your switch, cut the wire and crimp on the terminals required for your switch.

Pretty basic stuff.

blacksmith

instead of starting a new thread I figured we were talking about the same thing so I'll post it here I've got three wires going to the switch the light bar came with , this is the back of the switch I'd like to use the rocker switch ,what goes where I'm confused...

blacksmith

Ok so im guessing the blue wire is the switch led power wire , the white is positive to the light bar, and black is just a ground ?

blacksmith

Switch diagram

blacksmith

harness diagram

Laxman09

I imagine Ill have the same type of wiring set up when it gets here tomorrow. Hopefully someone can provide an answer as Im not that experienced with wiring.

blacksmith

I think we got them stumped with this one I'm going to do some more research and do some testing with a test light I'll let you know what I come up with

Laxman09

That would be great! My bar shows up today!

2010_FX4_Lux

No offense but this is pretty basic stuff. The best way to learn is search and read, then get out in the garage and get hands on experience.