2014 Screw Eco-sport truck built
#21
Senior Member
Looking good. I went 3/5.5 on my platinum then I put lowering shackles on the rear so I am roughly 7ish inches dropped in the rear. I am about to do an underbed notch and I am putting tremor 20s on my truck next weekend. Hopefully it will ride a little better than the low profile tires I have now.
#22
Senior Member
What shock setup you are running? I am wanting to lower the front of my truck another inch here soon. Looks killer.
#23
Member
Thread Starter
So this build I am trying to make a ecoboost Screw roush sport truck. 2wd version. I know roush and Shelby carter to the V8 like the 5.0 and 6.2s. Figure to replicate it for the ecos.
#27
Member
Thread Starter
#28
Senior Member
What shock and strut are you running up front?
#29
Member
Thread Starter
#30
Member
Thread Starter
Update 1-19-16* I just ordered some new goodies hopefully they should be shipped soon and in by next week.
Powerstop front breaks with cross drilled rotors and pads (#K3167)
aFe Power Silver Bullet throttle body spacer (#46-33017)
And finally going the change up my intake setup from K&N drop in filter to Airaid CAI.
Also I am in the process of using my aFe Bladerunner charge pipe to work with the on3 intercooler but I need to aluminum weld the on3 50mm BOV flange to the charge pipe.
Powerstop front breaks with cross drilled rotors and pads (#K3167)
aFe Power Silver Bullet throttle body spacer (#46-33017)
And finally going the change up my intake setup from K&N drop in filter to Airaid CAI.
Also I am in the process of using my aFe Bladerunner charge pipe to work with the on3 intercooler but I need to aluminum weld the on3 50mm BOV flange to the charge pipe.
Last edited by Ssbuilt808; 01-19-2016 at 07:23 PM.