Problem with idleing with edge
#1
03 F150 screw FX4 lariat
Thread Starter
Problem with idleing with edge
I have done the gotts mod, a cherry bomb glass pack muffler, and removed the catalytic converters. I run 91-93 octane and the truck runs great on lvl 3. When i go to make a custom tune i leave everything normal except put the timing at 1.50, shift pressure to 20% for all, and wot to 1.3 (was at 1.2 before changing). It will often die when i come to a stop sign. Any help? what have i dont wrong? the manuel says to set the timing to 1.50 when using 93 octane. Thanks
#2
Senior Member
did you mess with the idle option in the custom tunes? you can jack them up abit if its ideling to low!! my truck runs best on the tow level with my cai and exhaust!!
#3
03 F150 screw FX4 lariat
Thread Starter
#4
Senior Member
you can do the shift pressure with the edge!! but if you still have the ideling problem try to run on level 2 i was told that was the reccomended lvl to be on with a cai and exhaust and you can still do custom tunes on level 2!!
#5
03 F150 screw FX4 lariat
Thread Starter
lol i know thats what i am talking about, doing it myself...i just redid it i will try lvl 2 if it doesnt work this time
#6
Senior Member
ok man and if that still dont work put it back to stock and make sure its not doing it in stock level then you will know if its something else but if its only when you run on level 2 and 3 and you can figure it out call edge and see what they got to say!!
#7
will run you OVER
ya i had a problem with mine, i turned the idling too low that it wouldnt even idle, it would start and die. then i bumped it up and it idled about...300-400rpms (which you could almost could the firings of each cylinder and it ran soo rich too. just bump it up and mess with it.
Trending Topics
#8
03 F150 screw FX4 lariat
Thread Starter
it runs fine on the stock lvl 3 tune so i know its not my truck it just does it when i customize it
#10
03 F150 screw FX4 lariat
Thread Starter
lol i really screwed up now...i was changing the tune on my truck. It finished and said done. It went to the menu where it says power programming, diagnostics, performance tests, and setup. It froze there so i left it for about 10 minutes. Came back to find it still froze so i unplugged it and turned the key off then back on. Pluged it in and it gave me the error code 150. The odometer says -------- and it wont start. The edge says to call them so i will do that in the morning but i bet i am going to have to send it in. I am going to be stuck without my truck for a while probably.