whats the lowest setting you can run on the belltech front struts with a 4x4
(how many rings)
and still clear the cv shafts.
how low can you get and still align it with only notching out the control arm holes.

 

2" front/3" rear with the spring block removed.
I went with this kit because I didn't want to go "too" low with my 4x4 supercrew, it took my trailer ball hitch down 5 inches,
the kits for the 4x4 with the bigger front drop required trimming of the threaded ends of the tie rods, plus elongating the control-arm mounts which I didn't want to do.
I can easilly go back to stock ridse height with this.
This is where I landed:

 

3/5.5 belltech had to clearance the lower coil plate on struts