I posted yesterday on the "Thinking" thread but so far have seen no response, so I'll throw it out here where more might see it. I'm trying to find it for a friend to contemplate doing.

There was a thread on taking the 95 or newer Crown Victoria multifunction switch and reworking it to fit out GEN 10's, like the Harley Davidson have. I thought I saved it but can not find the link. The puts the chrome handle there, along with the chrome adjuster handle for the wheel. Another showed how to use the CV shift lever to get the chrome lever than seems to be gone from Ford's listings for the HD. Does anyone have it or a link similar saved they can share?

Thanks for any help.

 

I thought this would be a post about religion...

 

Sorry to burst your balloon. I don't do politics or religion in my posts. Keeps the tension down all around. LOL Both are just as bad when it comes to disagreements.and then it becomes a big brouhaha. .

 

I saw the light

 

One should always be sure to watch out for a big brouhaha. One must make sure it never turns into a ruckus. If you let it go too far it you may end up with complete pandemonium!!
Be sure to nip a big brouhaha in the bud.

By the way, I think I have looked at almost every thread in this section over the years and do not remember seeing anything about using a CV MF switch or shift lever. Could it have been at another forum?

 

Ak is this the thread you read.
https://www.ford-trucks.com/forums/1...ions-only.html

 

Thanks KD, but that one is the early trucks. There is one for the GEN 10's that uses a 95 up CV mf switch. Ford changed it in 95 and someone came up with a way to make it work. Two of the terms have to be swapped, I'm guessing on the plug itself. That's why I want to see the write up again and pass it along to another buddy. Thanks though.