Truck getting hotter than normal
#1
Senior Member
Thread Starter
Truck getting hotter than normal
Recently I've noticed the truck is getting hotter than normal. It happens when climbing a long steep 6% or more grade in 3rd gear between 55-65 mph. The outside temp is between 95 and 110 degrees and I am running the A/C. Now, I have always done it this way and I've never seen the needle move in the 5 years I've had the truck. The needle doesn't go into the red, there is still a pretty good gap before it gets there but it's enough to make me uncomfortable.
The truck is a 2000 5.4 extended cab with 204k miles.
As far as I know the radiator is factory.
I had the coolant flushed at some point but it's probably been a few years.
I'm sure the thermostat and water pump are factory as well.
This truck has spent it's life in Arizona and New Mexico so it's not a stranger to this dry heat. I'm thinking it's probably warn out blades on the water pump, but that's just my uneducated guess. Looking for some forum gurus on this one for ideas before I go throwing parts at it.
The truck is a 2000 5.4 extended cab with 204k miles.
As far as I know the radiator is factory.
I had the coolant flushed at some point but it's probably been a few years.
I'm sure the thermostat and water pump are factory as well.
This truck has spent it's life in Arizona and New Mexico so it's not a stranger to this dry heat. I'm thinking it's probably warn out blades on the water pump, but that's just my uneducated guess. Looking for some forum gurus on this one for ideas before I go throwing parts at it.
#2
Senior Member
Recently I've noticed the truck is getting hotter than normal. It happens when climbing a long steep 6% or more grade in 3rd gear between 55-65 mph. The outside temp is between 95 and 110 degrees and I am running the A/C. Now, I have always done it this way and I've never seen the needle move in the 5 years I've had the truck. The needle doesn't go into the red, there is still a pretty good gap before it gets there but it's enough to make me uncomfortable. The truck is a 2000 5.4 extended cab with 204k miles. As far as I know the radiator is factory. I had the coolant flushed at some point but it's probably been a few years. I'm sure the thermostat and water pump are factory as well. This truck has spent it's life in Arizona and New Mexico so it's not a stranger to this dry heat. I'm thinking it's probably warn out blades on the water pump, but that's just my uneducated guess. Looking for some forum gurus on this one for ideas before I go throwing parts at it.
#5
Senior Member
How much hotter is it getting? When it's been in the upper 90's here, my truck is getting as high as 198 degrees. In the winter, it stays right on 194 nearly all the time. It's supposed to hit 100 tomorrow... I'll have to watch it again.
#6
Senior Member
Thinking the same, yea, you don't want these getting hot. If the pump hasn't been looked at in a good long while, I'd just swap it out and change the stat for good measure. Very good with keeping an eye on it, - may of just saved yourself an engine.
The following users liked this post:
DrillRig52 (06-27-2016)
Trending Topics
#9
I replaced all the stuff you are looking to replace a couple summers ago. My cylinder head temp reading on my Edge would climb over 210 regularly. After the change, it stays between 200 and 210 mainly unless I'm going up a grade like you mentioned. It'll approach 220 but immediately drop at the top of the grade.
#10
Senior Member
Your rad could be done too. It could be rusted/clogged up on the inside.
Have a look at the cooling fins and gently run your finger across them, if they collapse or break off your rad is worn out.
Have a look at the cooling fins and gently run your finger across them, if they collapse or break off your rad is worn out.