hey so for xmas im thinking of getting a remote start. buti have noooo idea what to get. ive searched but nothing really told me what i want to know. all i want is a remote start and also able to lock/unlock doors. and have a reliable brand! thanks

 

vipers and python are the leading two brands in aftermarket security. both are great products

www.viper.com/
www.pythoncarsecurity.com/

 

I've used both ultrastart and compustar systems in the past. They're all pretty similar, but I found the ultrastart had better directions.

 

well i know of clifford, viper and python but im wondering whats best for its value and easiest to wire. im just scared to wire it in. and the P.A.T.S

 

Code Alarm makes a really good product for the money. And they are usually priced a lot lower than viper etc. I always go with viper, but if money was tight Code Alarm would be my next choice.

 

Viper and python are basically the same, viper the better. Spend the money on a good system. I hope if you plan on installing it that you would read the whole instruction manual first, then set it all up on a "bench" to mock up the install. The toughest part is finding the appropriate wire. I would definitely solder your connections.
Good luck!

 

any directed product (viper and python) you cant go wrong with either, check amazon out, they usually have good prices.

some quick info for you man.

anytime you buy an aftermarket start or security system you CANNOT get cutomer service help, especially with any directed product. there are some products out there that will offer DIY installer help but only a couple, bulldogsecurity is one of them. most companies only give customer service to licensed installers.

all the systems will be similar with installation as far as wire hook up ignition wire, ignition 2 wire, acc wire, starter wire, 12v constant, ground, parking lights/horn, transponder and door locks if you want. with the door locks you may need to use a relay to reverse the signal (ex. system may require a - output when the vehicle system has a + output)

the wiring is not hard if you have the proper know how of electrical work and you know how to test wires for voltage.

http://www.bulldogsecurity.com/bdnew...ngdiagrams.asp

this website gives all wire colors and locations, just find your year vehicle. even though you have the proper wire colors on this chart it is always a good idea to test wires before installing or splicing any wire to make sure the wire is what the paper says it is even if its the right color code.

some say to use solder when installing remote starters i say NO its a pain in the *** to get under there and solder plus what happens if you want to take the system out? im a firm believer in using solder on everything electrical but this is one thing that shouldnt be soldered. just strip some coating off (without cutting the wire in half) split the barewires into an "o" shape and put the wire that you need to splice inplace through the "o" and twist it good then tape it. give it a tug to make sure its tight. i do mine this way and have no problems.

another idea that helps when installing is sit down when you get the system before youre ready to install it and take some tape and label each wire so you dont have to keep looking at the instructions to make sure you have the proper wire.

you will also need a transponder, i would recommend XPRESSkit transponders, good systems and good instructions. the transponder hooks up to the remote start and the vehicle, you will have instructions to tell you what wires to hook where. you will also have to look at your PATs plug and identify it on a chart from XPRESSkit to make sure you have the proper wire coding.

one last very important tip, READ THE WHOLE MANUAL lol trust me, its a good thing to do.