I am trying to replace the passenger side window motor in my 99 and I have pulled hard enough that something should have at least broken by now but the door panel is still on and i am wondering what I am doing wrong or what is the secret I am missing?? Please Help
Michael

 

Front Door Trim Panel
Removal and Installation
Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
Remove the front door trim moulding.
NOTE: Use the notch to remove the component.
Remove the interior door handle finish panel.
If equipped, remove the window regulator switch plate (14524).
Lift the front of the window regulator switch plate.
Disconnect the electrical connectors.
If equipped, remove the window regulator handle (23342).
Separate the handle cover from the handle.
Remove the screw.
Remove the window regulator handle.
Remove the spacer.
CAUTION: Do not pull directly outward on the front door trim panel, as damage may occur.
Remove the front door trim panel.
Remove the screws.
Lift and remove the front door trim panel.
If equipped, twist the courtesy lamp bulb socket one quarter turn and remove the socket from the front door trim panel.
To install, reverse the removal procedure.

 

you have to pull up....i found that out when i broke it...

 

me too!

 

use a straight screw driver pop off the peaice that up the back of the window then there is a screw there and you also have to pull the handle cover off with a straight just pop it then take that screw out and lift up disconnect the switchs and the door light and there you go that easy