wassap yall. Need sum help with this cluster. can someone give me a detailed explanation on how to either fix or repair? So it my whole right side stopped working today apparently, temp, voltage, and rpms. Gauge pins did not move whatsoever, but it was fine yesterday. took apart cluster and checked stepper motors and all and seemed ok, eventually got all pins to move around again and everything but now everything is off even after i “calibrated” the pins by reinserting them at their zero point. now when i start the truck or do the diagnostic gauge check they dont go where their supposed to. i really need help so i can drive with the correct information

 

Might need to reflow some of the solder joints on the circuit board for you cluster, those are a fairly common pain point in these trucks.