Extended can seat issue
#1
Senior Member
Thread Starter
Edit: stupid autocorrect... Title should be extended cab not can
So I'm trying to pull out my back seat (60/40) bench and ran into an issue. The torx screws that hold the bench support and bottom seatbelt are stuck. I broke off one bit and then twisted another bit and the 3rd bit tried and impact wrench and still didn't budge. Everything looks clean, is there something I'm missing to take those screws out or was there loctite put on those? Any advice to get those out would help, thanks
So I'm trying to pull out my back seat (60/40) bench and ran into an issue. The torx screws that hold the bench support and bottom seatbelt are stuck. I broke off one bit and then twisted another bit and the 3rd bit tried and impact wrench and still didn't budge. Everything looks clean, is there something I'm missing to take those screws out or was there loctite put on those? Any advice to get those out would help, thanks
#3
Senior Member
Thread Starter
#6
Senior Member
I second the impact driver. Watch your fingers.
#7
Senior Member
Thread Starter