Topic Sponsor
1997 - 2003 Ford F150 General discussion on the Ford 1997 - 2003 F150 truck.

Engine Shakes After Gotts/Silencer Mod

Thread Tools
 
Search this Thread
 
Old 06-16-2016, 01:39 PM
  #31  
Senior Member
 
akdoggie's Avatar
 
Join Date: Jul 2010
Location: Alaska
Posts: 8,510
Received 2,508 Likes on 1,818 Posts

Default

I have K&N's in all my vehicles. Alaska is very dusty due to all the glaciers. Fram/Motorcraft and etc filters just don't do it. I've used this brand since the 90's in most of my prior vehicles also. I have never had one problem with a MAF sensor in my Fords. GM, oh yeah, but not the single little MAF Ford uses.

I clean my air filter, use a light spray, let it sit for 30 minutes and reinstall it when the oil is changed and done. I have never noticed a difference in my performance, but the idle is much more even with the K&N vs stock filter. I noticed this more in my 07 Mustang, than in the f150's I have.
Old 06-16-2016, 01:47 PM
  #32  
Senior Member
 
akdoggie's Avatar
 
Join Date: Jul 2010
Location: Alaska
Posts: 8,510
Received 2,508 Likes on 1,818 Posts

Default

Originally Posted by white89gt
I wound up tearing apart an amp just to have a look-see and found a bunch o' leaking caps in it. With Jbrews help identifying an issue or two, it'll be good as new when I get those replaced.

I also went ahead and made up my mind on my back... I decided I will do surgery. I can't take this shiznit any longer.
I certainly hope that your back surgery goes well. I had it done in 2004 and have regretted it ever since. The first surgery they fixed a couple cracked vert's, and had to remove some pieces of broke off bone.

I had to go back the second time to have more pieces removed that seemed attached during the first surgery. I finally had to have a 3rd surgery to fuse L4, L5 and S1. They put in an L plate and hooked it all together. The pain at times is really not acceptable, but I will be damned if I will go back for a 5th surgery. I had a fourth one, where they went in again to remove more pieces from the L3. I was on Fentanyl for my pain meds, and was doing fine, until the CDC decided that it was too powerful of a drug. They have made me taper off from 100mic's a patch, now down to 25mics each. That is a 300% loss of pain relief. NOT GOOD.

I certainly hope you will have better results than I did. Everyone is different, so you may be fine. Good luck White89GT.
Old 06-16-2016, 02:03 PM
  #33  
Senior Member
 
white89gt's Avatar
 
Join Date: Dec 2015
Location: Utah
Posts: 20,198
Received 6,482 Likes on 4,618 Posts

Default

Originally Posted by akdoggie
I certainly hope that your back surgery goes well. I had it done in 2004 and have regretted it ever since. The first surgery they fixed a couple cracked vert's, and had to remove some pieces of broke off bone.

I had to go back the second time to have more pieces removed that seemed attached during the first surgery. I finally had to have a 3rd surgery to fuse L4, L5 and S1. They put in an L plate and hooked it all together. The pain at times is really not acceptable, but I will be damned if I will go back for a 5th surgery. I had a fourth one, where they went in again to remove more pieces from the L3. I was on Fentanyl for my pain meds, and was doing fine, until the CDC decided that it was too powerful of a drug. They have made me taper off from 100mic's a patch, now down to 25mics each. That is a 300% loss of pain relief. NOT GOOD.

I certainly hope you will have better results than I did. Everyone is different, so you may be fine. Good luck White89GT.
I had my surgery on April 27th. So far, so good. I had a discectomy and a laminectomy. I still feel my sciatic if I turn or stretch it just so, but it's rare. I am 100% satisfied with my results, so far. I'm not saying that I am pain free, because it's still healing. But it is much much more tolerable. I couldn't sit or stand



Quick Reply: Engine Shakes After Gotts/Silencer Mod



All times are GMT -4. The time now is 05:38 PM.