Topic Sponsor
1997 - 2003 Ford F150 General discussion on the Ford 1997 - 2003 F150 truck.

Antifreeze Water or coolant disappears help

Thread Tools
 
Search this Thread
 
Old 10-01-2015, 12:23 PM
  #1  
Junior Member
Thread Starter
 
allbee1's Avatar
 
Join Date: Oct 2015
Posts: 12
Received 0 Likes on 0 Posts
Default Antifreeze Water or coolant disappears help

I have 98 Fl50 4.6 340k miles . I recently change intake gasket because I had a bad leak in heater pipe that runs under the manifold. Here is my issue I drive it 10 –25 miles a day everytime I check reserve tank it needs water I have to pour 2 gallons everyday or it will overheat on me. I have been looking for leak for 2 weeks now I can not find it. I put uv dye to nothing shows up, oil looks good, no white smoke and .no water inside floor . I do have a slight misfire on cylinder 2 that I have been try to fix only when warms up or under load. On that issue that may or may be related. New plugs. New wire, new coil, spark plug is not wet ,.

Any help would be greatly appreciated
Old 10-01-2015, 12:28 PM
  #2  
Mark
iTrader: (1)
 
techrep's Avatar
 
Join Date: Jan 2009
Location: Va. Beach, VA.
Posts: 36,870
Received 2,417 Likes on 2,118 Posts

Default

You need to perform a cooling system pressure test... 2 gallons a day is a lot !! you will see it somewhere when the system is pressurized..
Old 10-01-2015, 12:58 PM
  #3  
Junior Member
Thread Starter
 
allbee1's Avatar
 
Join Date: Oct 2015
Posts: 12
Received 0 Likes on 0 Posts
Default

that is my next step i expected pressure will drop but might not show me were . I am leaning toward head gasket or crack head but it is running good and stronger then ever. Because looking for misfire i have replace pvc and all vacuum lines
Old 10-01-2015, 07:54 PM
  #4  
Junior Member
Thread Starter
 
allbee1's Avatar
 
Join Date: Oct 2015
Posts: 12
Received 0 Likes on 0 Posts
Default test

Originally Posted by techrep
You need to perform a cooling system pressure test... 2 gallons a day is a lot !! you will see it somewhere when the system is pressurized..
i did the test took to 16 psi drop to 14 within a few min and held there. i found nothing so far . Should i put under presure and turn it on?
Old 10-02-2015, 01:34 AM
  #5  
2003 FX4 Supercrew
 
2002FX4's Avatar
 
Join Date: Aug 2010
Posts: 732
Received 76 Likes on 54 Posts

Default

Rent a Block test kit from a parts store. It will show if there is exhaust gases in your coolant. If there is, head gaskets.
Old 10-02-2015, 03:26 AM
  #6  
Senior Member
 
Carcrazygts2's Avatar
 
Join Date: Sep 2011
Posts: 7,381
Received 434 Likes on 419 Posts

Default

Sounds like head gaskets. Like stated above get a Engine block tester kit. You have to check it with the engine cold along with at operating temperature.
Old 10-02-2015, 03:42 AM
  #7  
WindowGuy
 
jkenprice1's Avatar
 
Join Date: Dec 2012
Location: Indianapolis
Posts: 1,323
Received 153 Likes on 135 Posts

Default

Congrats on 340,000 miles
The following users liked this post:
allbee1 (10-02-2015)
Old 10-02-2015, 12:51 PM
  #8  
Junior Member
Thread Starter
 
allbee1's Avatar
 
Join Date: Oct 2015
Posts: 12
Received 0 Likes on 0 Posts
Default

I change the oil just for the heck of it oil is clean no water. I will do head gasket test today. This truck is running so good and strong the ac on it is better then my cts you have to lower it because it will freeze you. I would just hate to part with this truck. if it turns out its the head gasket with 340k will it even be worth it?
Old 10-02-2015, 02:54 PM
  #9  
Junior Member
Thread Starter
 
allbee1's Avatar
 
Join Date: Oct 2015
Posts: 12
Received 0 Likes on 0 Posts
Default

Originally Posted by allbee1
I have 98 Fl50 4.6 340k miles . I recently change intake gasket because I had a bad leak in heater pipe that runs under the manifold. Here is my issue I drive it 10 –25 miles a day everytime I check reserve tank it needs water I have to pour 2 gallons everyday or it will overheat on me. I have been looking for leak for 2 weeks now I can not find it. I put uv dye to nothing shows up, oil looks good, no white smoke and .no water inside floor . I do have a slight misfire on cylinder 2 that I have been try to fix only when warms up or under load. On that issue that may or may be related. New plugs. New wire, new coil, spark plug is not wet ,.

Any help would be greatly appreciated
just did head gasket test and to my suprise the liguid stood clear as as can be know i am really dumbfounded!
Old 10-02-2015, 02:57 PM
  #10  
Junior Member
Thread Starter
 
allbee1's Avatar
 
Join Date: Oct 2015
Posts: 12
Received 0 Likes on 0 Posts
Default

Originally Posted by Carcrazygts2
Sounds like head gaskets. Like stated above get a Engine block tester kit. You have to check it with the engine cold along with at operating temperature.
Just did block test fluid to my suprise it stays clear as can be dumbfounded!!


Quick Reply: Antifreeze Water or coolant disappears help



All times are GMT -4. The time now is 03:47 AM.