What did you do to your 11th gen today?
#2182
Moderator (Ret.)
Installed a set of factory wheel well trim I bought from site member MPD.
I did not drill side holes to mount them, nor was two sided tape used. Instead, I used some 1 inch fasteners like the picture below for the inner wheel well holes. They are snug, and will not come off unless you cut the plastic heads off. These fasteners are flush. NAPA or any good hardware store carry them (not Lowes or Home Depot).
I did not drill side holes to mount them, nor was two sided tape used. Instead, I used some 1 inch fasteners like the picture below for the inner wheel well holes. They are snug, and will not come off unless you cut the plastic heads off. These fasteners are flush. NAPA or any good hardware store carry them (not Lowes or Home Depot).
#2184
#2185
Chive So Hard
#2186
Senior Member
Turned my idle up by 60 rpms and guess what the annoying shake disappeared haha. I called PHP first to see if this was action since every place I've been to says there is nothing wrong