PICS...6" RCX lift, MotoMetal 951's, 6" lift Bilsteins, Bushwhackers, and Toyo M/T's
#1
Black & Chrome
Thread Starter
PICS...6" RCX lift, MotoMetal 951's, 6" lift Bilsteins, Bushwhackers, and Toyo M/T's
So all my new parts are finally on, some of which have been sitting at my house anxiously awaiting me to put them on since last fall. Here's the breakdown of my old and new setup...
Previous parts that were removed...
2.5" HBS Spacer
1" extra block in the rear
And just added all this...
6" RCX Lift
6" Lift Bilsteins (Struts & Shocks)
20x10 MotoMetal 951's (4.79" backspacing w/ -18mm offset)
35x12.50-20 Toyo Open Country M/T's
Bushwhacker Pocket Style Flares
Here's the only completely stock pic that I have...
Here's a couple of it leveled...
Previous parts that were removed...
2.5" HBS Spacer
1" extra block in the rear
And just added all this...
6" RCX Lift
6" Lift Bilsteins (Struts & Shocks)
20x10 MotoMetal 951's (4.79" backspacing w/ -18mm offset)
35x12.50-20 Toyo Open Country M/T's
Bushwhacker Pocket Style Flares
Here's the only completely stock pic that I have...
Here's a couple of it leveled...
#6
Member
looks amazing man! haha i was just messing around.
So is it more then a 6in lift with the bilsteins now? looks much taller then my truck. i really like the flares too, i am usually kind of a huge hater on aftermarket flares but those look good.
So is it more then a 6in lift with the bilsteins now? looks much taller then my truck. i really like the flares too, i am usually kind of a huge hater on aftermarket flares but those look good.
#7
so bonez...if you dont mind me asking...how much do you have invested in all those mods? Mine is all stock and am looking to maybe do something similar. Also...could u have gone with a bigger tire with that setup? thanks..truck looks great.
Trending Topics
#8
Black & Chrome
Thread Starter
1) It only came with a 5" block for the rear. The stock block was 2" and on a 6" lift, you need 6" in the front and 4" in the rear to make it leveled out, so I would have needed a 6" block to get 4" of lift in the rear.
2) I read on here somewhere that the front drop cross-members were only 5", so that would also be 1" short of a true 6" lift.
So now that the front is 1.5" higher than the rear, I just bought a set of 1.5-2" add-a-leafs for the rear to level it out, so to answer your question, I think it might be a little taller than just putting the RCX 6" lift kit on as it comes out of the box, but I'm not 100% sure since I don't really have anything to compare it too.
#10
Black & Chrome
Thread Starter
I think all my mods are listed in my sig, and for all of that I think I have slightly over 5k invested in all of it. I got a couple sweet deals on the edge, rims and K&N, so if you bought all that stuff at retail price, it would be a little higher. I also shopped around on everything I bought looking for the best deals. With a narrower tire, you might be able to get 37's to fit, but with a 12.50 on the width, I think it would take a fair amount of trimming or just dealing with the rubbing. I had to trim a small piece off the front valence to make these work.