Im curious if i have to worry about this or not? When i unlock my truck all my lights turn on whether its the keypad or keyfob. If it is a problem how can i take it off?

 

Its in you owners manual. But just do a search theres a bunch of threads and info on it. Takes like 2 min.

 

Look in your f150 manual pg 137 I believe, I did this and it worked great

 

Left mine on and have been with HID's for about 5 years now and no problems

 

Sorry making another thread instead of searching, it was on my mind before my class started so i didnt have time to search.
Well if it works for you just fine then i think im in the clear
Thanks!

 

Thanks for the info looking to do the same thing

 

So i couldnt fid in the manual where i go to shut off the peimeter lighting if anyone can tell me how to thatd be awesome! Please
Ha 04 f150 xlt

 

I believe the truck has to be taken to the Dealer.

The computer has to be re programmed

 

Page 92

Enabling/disabling the perimeter lighting feature
Your vehicle comes with the perimeter lighting feature enabled. All
vehicle doors must be closed before beginning the procedure. You must
complete Steps 1–5 within 30 seconds, or the procedure will have to be
repeated. If the procedure needs to be repeated, you must wait a
minimum of 30 seconds to begin again.
1. Turn the ignition to the 3 (ON) position, then press the control
three times.
2. Turn the ignition to the 1 (OFF/LOCK) position, then press the
control three times.
3. Turn the ignition to the 3 (ON) position; the horn will chirp to
indicate the driver configuration mode has been activated.
4. Within five seconds, press the control two times. Note: One horn
chirp should be heard, indicating the system has been disabled.
Conversely, a horn chirp followed by a honk will indicate the system is
enabled. Pressing the power door control two times again will turn
the feature ON if it was previously OFF, or OFF if it was previously ON.
Every two consecutive presses of the control after successfully
entering the configuration mode will change the enable/disable condition
of the feature.
5. Turn the ignition to the 1 (OFF/LOCK) position to exit programming.
Note: After exiting the driver configuration mode, the horn will chirp
once to indicate a feature has been activated/deactivated.

 

Sweet it worked thanks